T-45C Goshawk for MSFS

CHANGE LOG

Version 1.4.0 – April 30 2024

Version 1.3.9 – April 22nd 2024

- Fixed "Moongoose Voice" caption
- Minor tweaks to engine thrust curves
- Minor tweaks to drag curves and coefficients

AVIONICS UPDATE
- Fixed bug causing MFD-HUD mode to display speeds below 50 knots
- Fixed bug causing incorrect Fuel Flow readings both on the FF indicator and MFD
- Fixed behavior of CDI Course Line in MFD-HSI page if ILS is selected (line should point to Localizer)
- Fixed behavior of Command Heading Marker on HUD and ADI, so that now it correctly reflects the selected heading if ILS is selected
- Improved accuracy of Command Heading Marker on HUD
- ILS can now be selected both in Plan and CDI mode if frequency is available
- ILS option will not display bearing anymore as per flight manual
- Added TILS and WILS steering modes (ILS bars + TACAN or Waypoint)
- CDI will now indicate the ILS course and deviation if ILS is selected singly (will indicate TACAN or Waypoint deviation in WILS and TILS modes)
- ILS bars now require the pilot to select ILS option in the HSI (will not show automatically)
- Revised TPHOT warning conditions
- Barometric altimeter digits will show in 20 feet increments as per flight manual
- Barometric altimeter digits will flash for 5 seconds when crossing 18,000ft as per flight manual
- Data block will not show TTS for ILS, TILS and WILS mode as per flight manual
- Added callsigns to configuration files
- Fixed tail code for VT-86 special livery

Version 1.3.1 – April 17th 2023 Minor update - Further tweaks to elevator trim effectiveness at lower speed - Tweaks to aileron effectiveness - Fixed bugs in aileron and rudder trim needles - Fixed minor typos in checklists

Version 1.3.2 – May 4th 2023
Minor update
- Fixed AoA bracket movement
- Changed speedbrake blowback code to support analog axis (courtesy of Romain
Rivière)
- Added code to support JBD animations on dynamic Ford carrier
- Fixed LBAR green light behavior (should be OFF before cat launch)
Note: this can now be used as an indicator that the cat launch code is working and
the aircraft is ready to launch